Sr.No. Component Drawing No. MOC- (Material) Dimension (L X W X H) mm Weight (kg) Production Rate/Shift
01
02
03
04
05

  Sr.No.      
  01   Loading height from
floor level (mm)

  02   Preferred component
orientation if any

  03   Component flow: left to
right/ right to left

  04   Facility available for
loading-unloading : YES or NO & Type

  05   Type of machine required :
[ standard/front load-unload/through feed Conveyorised]

  06   Space available for machine :
L x W x H mm (Provide shop floor layout drawing. With proposed m/c location)

  07   Component flow :
Single Piece Or Batch

  08   No. of shifts per day :
1/2/3/ anything else

  09   Effective minutes per shift
( operator efficiency) : %

  10   Ambient Temperature :
Minimum & maximum Deg. C

  11   Material of construction :
SS304 or MS wet parts : SS304, Non wet parts : SS304 or MS

  12   Heating mode : Electrical/
Hot Water/ Steam/ Thermic Fluid

  13   Expected initial heat up
time of solution (Hrs.)

  14   Control Panel : Contractor-
Relay logic/PLC & MMI LOGIC


Sr.No.   Description   Remark
  01   Process Prior To Cleaning Machine

  02   Process After Cleaning Machine

  03   Method Of Checking Cleanliness Level :
Visual Checking/ Millipore Test/ Any Other
  04   Post Wash Condition :
Semi Dry Or Fully Dry
  05   Any special requirement


Sr. No.   Description   Remark
  01   Water (required less than 100 PPM)


  02   Compressed Air (Dry/Wet)


  03   Electrical Power: Supply Voltage

   :Control Voltage

  04   Variation in electrical supply : Voltage

   :Frequency

  05   Cleaning chemical : (if any) Make & Name

   :Concentration & pH value


Sr. No.   Description   Remark
  01 TYPE :   
  1.   Oil (Type)


  2.   Loose chips


  3.   Dust (Casting Or Atmospheric)


  4.   Grease


  5.   Lapping/Buffing paste


  6.   Any other


  02 MATERIAL :   
  1.   Ferrous ( CI/CS/MS/SS/SGI)


  2.   Non-ferrous (Metal/Non Metal)


  3.   Fibrous


  4.   Any other


  03   Approximate size & nature of contamination :(granular/needlelike/flakes)


  04   Nature of contamination :(Free falling/ sticky/ smudgy )


  05   Weight : (mg/component)



Sr.No.   Description   Remark
  01   Type of machine, make, year of supply :


  02   Chemical used:


  03   Improvement expected over present method:

  04   Cleaning method